2010-2011 Cummins 6.7L ECM (Engine Control Module) Flash (Reprogramming)...
VEHICLE: 2010-2011 Ram 2500/3500/4500/5500 6.7L Cummins ECU: CM2200 Cummins ECM ERROR: Device did not respond when sending Transfer Data request DESCRIPTION: ...
View Article2008–2012 PM/MK (Caliber/Compass/Patriot) Transmission Control Module (TCM)...
VEHICLE: 2008-2012 PM (Caliber) 2008-2012 MK (Compass/Patriot) ECU: Transmission Control Module (TCM) ERROR MESSAGE: Negative response 0x80 - 'Service Not Supported In Active...
View Article2005/2006 ND (Dakota) Occupant Restraint Controller (ORC) Flash Process...
VEHICLE: 2005/2006 ND (Dakota) ECU: Occupant Restraint Controller (ORC) ERROR MESSAGE: Negative response 0x11 - 'Service Not Supported' received from Start Diagnostic...
View Article2010-2011 Cummins 6.7L ECM (Engine Control Module) Flash (Reprogramming)...
VEHICLE: 2010-2011 Ram 2500/3500/4500/5500 6.7L Cummins ECU: CM2200 Cummins ECM ERROR MESSAGE: Error received retrieving channel parameter - Unable to open...
View Article2007-2010 JK (Wrangler) KA (Nitro) Cabin Compartment Node (CCN) Flash...
VEHICLE: 2007-2010 JK Wrangler, all engines 2007-2010 KA Nitro, all engines ECU: Cabin Compartment Node (CCN) Cluster POTENTIAL ERROR ME SSAGES: No response received from...
View Article2004-2005 HB and 2005 LX Next Generation Controller (NGC) Powertrain Control...
VEHICLES: 2004-2005 HB Durango and 2005 LX 300/Magnum/Charger DESCRIPTION: If the flash fails or is aborted on the above vehicles this PCM will become unusable and replacement will be required. If the...
View Article2011 LX/LD (300C/Charger) JC (Journey) Body Control Module/Common Body...
VEHICLES: 2011 LX/LD (300C/Charger) 2011 JC (Jouney) DESCRIPTION: If the flash fails or is aborted at a particular point in the flash process on these vehicles, the BCM ECU MAY...
View Article2011 JC/JF/LD/LX (Journey/Charger/300) Hands-Free Module (HFM) ECU Flash Failure
VEHICLES: 2011 JC/JF/LD/LX DESCRIPTION: The Magneti Marelli HFM USB flash process failed and the ECU is no longer responsive; the ECU now shows up “red” in the vehicle view. If the HFM flash process is...
View ArticleNGC4 PCM (Powertrain Control Module) Flash Process Fails with "No Response...
VEHICLE: 2007+ vehicles with 2.7L, 3.5L 3.7L, 3.8L, 4.0L 4.7L, 5.7L, or 6.1L engines using NGC4 PCM ECU: NGC4 (Next Generation Controller) DESCRIPTION: Flash process fails with message, "No...
View Article2012-2013 JC/JF (Journey/Freemont) Antilock Brake System/Electronic Stability...
VEHICLES: 2012-2013 JC/JF (Journey/Freemont) ECU: ABS/ESP (Antilock Brake System/Electronic Stability Program) POSSIBLE ERROR MES SAGES: Negative response 0x7f - 'Service Not...
View ArticleUnable to Flash Reprogram Vehicle ECUs Using StarSCAN
ERROR MESSAGE: Unable to flash with StatSCAN: "Only the StarMOBILE or the wiTECH system can perform this action" DESCRIPTION: Due to the ongoing increase in vehicle and ECU technology, new flash files...
View Article2013 PF (Dart) PCM (Power Train Contol Module) Post Flash Reprogramming...
VEHICLE: 2013 - 2014 PF (Dart) 1.4L Turbo ECU: 8GMW PCM 8GMK PCM ISSUE: Certain procedures must be performed on an 8GMW and 8GMK PCM for PF 1.4L after flash...
View Article2014 KL (Cherokee) IPC (Instrument Panel Cluster) non-functional with codes...
Vehicle: 2014 KL (Cherokee) ECU: IPC (Instrument Panel Cluster) Potential Issue: IPC ECU (Electronic Control Module) part number may not update to the new expected part number and the IPC ECU is in a...
View Article2013-2014 WK/DS (Grand Cherokee and Ram 1500) Air Suspension Module (ASCM)...
2013-2014 WK (Grand Cherokee) 2013-2014 DS (Ram 1500) ASCM Air Suspension Control Module All general flash procedures in the service...
View ArticleFinding Aftermarket equipment on vehicles
DESCRIPTION ECU Flash Reprogramming and Diagnostic Routine failures have been known to be caused by aftermarket equipment installed on a vehicle. If an ECU flash reprogramming session or routine fails...
View Article2011 JC/JF/LD/LX (Journey/Charger/300) Hands-Free Module (HFM) Error Occurred...
VEHICLES: 2011 JC Journey 2011 JF Journey (Fiat) 2011 LD Charger 2011 LX 300 DESCRIPTION: A USB cable is required to flash the Magneti Marelli HFM ECU. If the cable is not connected when...
View ArticleSafety Recall G40 for EBC/ABS Module Flash Resulting in 'Flash Process Failed'
Issue While performing Safety Recall G40, for an ABS Module Flash, user may experience a 'Flash Process Failed' message. During the flash, user will experience 'Programming ABS Code Block #7 of 7 -...
View ArticleUnable to Flash 2009 DS Replacement PCM due to ‘Invalid Part Number’
Date: 11/3/2009 - Update A TIPM ECU flash release has been submitted to the field to address this issue, and is now available. Please refer to TSB 08-018-09, and first update the TIPM if applicable....
View Article2012 LD/LX (Charger/300C) PCM (Power Train Control Module) “Flash process...
Vehicles effected: 2012 LD/LX (Charger/300) using a GPEC2 ECU: GPEC2 PCM Issue: Flashing a GPEC2 PCM on 2012 LD/LX may result in an error message of “Flash process failed - Could not open required...
View Article2012 FF (Fiat 500) Flash Reprogramming Failure Results in Multiple Retries
2012 FF (Fiat 500) Flash Reprogramming Failure Results in Multiple Retries Vehicle Effected: 2012 FF (Fiat 500) ECU: 8GMC PCM (Powertrain Control Module) Subject: There was an issue identified with the...
View Article