DCCTools Knowledgebase KB (ECU Reprogramming (Flash))

VEHICLE: 2010-2011 Ram 2500/3500/4500/5500 6.7L Cummins ECU: CM2200 Cummins ECM ERROR: Device did not respond when sending Transfer Data request DESCRIPTION: ...

VEHICLE: 2008-2012 PM (Caliber) 2008-2012 MK (Compass/Patriot) ECU: Transmission Control Module (TCM) ERROR MESSAGE: Negative response 0x80 - 'Service Not Supported In Active...

VEHICLE: 2005/2006 ND (Dakota) ECU: Occupant Restraint Controller (ORC) ERROR MESSAGE: Negative response 0x11 - 'Service Not Supported' received from Start Diagnostic...

VEHICLE: 2010-2011 Ram 2500/3500/4500/5500 6.7L Cummins ECU: CM2200 Cummins ECM ERROR MESSAGE: Error received retrieving channel parameter - Unable to open...

VEHICLE: 2007-2010 JK Wrangler, all engines 2007-2010 KA Nitro, all engines ECU: Cabin Compartment Node (CCN) Cluster POTENTIAL ERROR ME SSAGES: No response received from...

VEHICLES: 2004-2005 HB Durango and 2005 LX 300/Magnum/Charger DESCRIPTION: If the flash fails or is aborted on the above vehicles this PCM will become unusable and replacement will be required. If the...

VEHICLES: 2011 LX/LD (300C/Charger) 2011 JC (Jouney) DESCRIPTION: If the flash fails or is aborted at a particular point in the flash process on these vehicles, the BCM ECU MAY...

VEHICLES: 2011 JC/JF/LD/LX DESCRIPTION: The Magneti Marelli HFM USB flash process failed and the ECU is no longer responsive; the ECU now shows up “red” in the vehicle view. If the HFM flash process is aborted or fails...

VEHICLE: 2007+ vehicles with 2.7L, 3.5L 3.7L, 3.8L, 4.0L 4.7L, 5.7L, or 6.1L engines using NGC4 PCM ECU: NGC4 (Next Generation Controller) DESCRIPTION: Flash process fails with message, "No...

VEHICLES: 2012-2013 JC/JF (Journey/Freemont) ECU: ABS/ESP (Antilock Brake System/Electronic Stability Program) POSSIBLE ERROR MES SAGES: Negative response 0x7f - 'Service Not...

ERROR MESSAGE: Unable to flash with StatSCAN: "Only the StarMOBILE or the wiTECH system can perform this action" DESCRIPTION: Due to the ongoing increase in vehicle and ECU technology, new flash files released by...

VEHICLE: 2013 - 2014 PF (Dart) 1.4L Turbo ECU: 8GMW PCM 8GMK PCM ISSUE: Certain procedures must be performed on an 8GMW and 8GMK PCM for PF 1.4L after flash...

Vehicle: 2014 KL (Cherokee) ECU: IPC (Instrument Panel Cluster) Potential Issue: IPC ECU (Electronic Control Module) part number may not update to the new expected part number and the IPC ECU is in a non-functional state...

2013-2014 WK (Grand Cherokee) 2013-2014 DS (Ram 1500) ASCM Air Suspension Control Module All general flash procedures in the service...

DESCRIPTION ECU Flash Reprogramming and Diagnostic Routine failures have been known to be caused by aftermarket equipment installed on a vehicle. If an ECU flash reprogramming session or routine fails repeatable and all procedures in...

VEHICLES: 2011 JC Journey 2011 JF Journey (Fiat) 2011 LD Charger 2011 LX 300 DESCRIPTION: A USB cable is required to flash the Magneti Marelli HFM ECU. If the cable is not connected when...

Issue While performing Safety Recall G40, for an ABS Module Flash, user may experience a 'Flash Process Failed' message. During the flash, user will experience 'Programming ABS Code Block #7 of 7 - 100%' followed by 'Flash Update...

Date: 11/3/2009 - Update A TIPM ECU flash release has been submitted to the field to address this issue, and is now available. Please refer to TSB 08-018-09, and first update the TIPM if applicable. Then, proceed with flashing the...

Vehicles effected: 2012 LD/LX (Charger/300) using a GPEC2 ECU: GPEC2 PCM Issue: Flashing a GPEC2 PCM on 2012 LD/LX may result in an error message of “Flash process failed - Could not open required hardware channel...

2012 FF (Fiat 500) Flash Reprogramming Failure Results in Multiple Retries Vehicle Effected: 2012 FF (Fiat 500) ECU: 8GMC PCM (Powertrain Control Module) Subject: There was an issue identified with the...

2010-2011 Cummins 6.7L ECM (Engine Control Module) Flash (Reprogramming) Failure: Device Did Not Respond when Sending Transfer Data Request

2008–2012 PM/MK (Caliber/Compass/Patriot) Transmission Control Module (TCM) Flash Process Failure: Negative Response 0x80 - "Service Not Supported In Active Diagnostic Session" Received from Transfer Data Request

2005/2006 ND (Dakota) Occupant Restraint Controller (ORC) Flash Process Failure: Negative Response 0x11 - 'Service Not Supported' Received from Start Diagnostic Session Extended Request

2010-2011 Cummins 6.7L ECM (Engine Control Module) Flash (Reprogramming) Failure: "Error Received Retrieving Channel Parameter - Unable to Open Channel!"

2007-2010 JK (Wrangler) KA (Nitro) Cabin Compartment Node (CCN) Flash (Reprogramming) Process Failed

2004-2005 HB and 2005 LX Next Generation Controller (NGC) Powertrain Control Module (PCM) Unresponsive After Flash (Reprogramming) Abort or Failure

2011 LX/LD (300C/Charger) JC (Journey) Body Control Module/Common Body Controller (BCM/CBC) Flash Failure or Abort

2011 JC/JF/LD/LX (Journey/Charger/300) Hands-Free Module (HFM) ECU Flash Failure

NGC4 PCM (Powertrain Control Module) Flash Process Fails with "No Response Received from Transfer Data Request"

2012-2013 JC/JF (Journey/Freemont) Antilock Brake System/Electronic Stability Program (ABS/ESP) Flash Process Failure

Unable to Flash Reprogram Vehicle ECUs Using StarSCAN

2013 PF (Dart) PCM (Power Train Contol Module) Post Flash Reprogramming Procedures

2014 KL (Cherokee) IPC (Instrument Panel Cluster) non-functional with codes set after a successful flash reprogramming.

2013-2014 WK/DS (Grand Cherokee and Ram 1500) Air Suspension Module (ASCM) Unresponsive After a Flash Failure

Finding Aftermarket equipment on vehicles

2011 JC/JF/LD/LX (Journey/Charger/300) Hands-Free Module (HFM) Error Occurred Executing Plugin Flash Module

Safety Recall G40 for EBC/ABS Module Flash Resulting in 'Flash Process Failed'

Unable to Flash 2009 DS Replacement PCM due to ‘Invalid Part Number’

2012 LD/LX (Charger/300C) PCM (Power Train Control Module) “Flash process failed - Could not open required hardware channel to vehicle"

2012 FF (Fiat 500) Flash Reprogramming Failure Results in Multiple Retries